Advertisement
A.5 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
A
NOTES AND WARNINGS
• To run procedures A.5.1.A and A.5.2.A, you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must
have the "PRG" and "ESC" buttons (like "ERA P" and "ERA W" transmitters).
• To run procedures A.5.1.B and A.5.2.B you must have a new transmitter to memorise, chosen from the "Nice Screen" catalogue , and an old previously memorised
transmitter.
A.5.1 - To memorise the transmitter buttons in "Mode I" ("Standard mode")
• Procedures A.5.1A and A.5.1.B memorise all the new transmitter's buttons in "Mode I", with the same configuration as the old transmitter (for details about "Mode
I" see par. 3.4.1-A).
A.5.1.A - Procedure for transmitters equipped with the "PRG" and "ESC" buttons ("ERA P" and "ERA W")
1
OLD
On the OLD transmitter: hold down the
button and
2
= 5 sec
PRG
NEW
On the NEW transmitter: hold down
the button and
A.5.1.B - Procedure for transmitters without the "PRG" and "ESC" buttons"
1
= 8 sec
NEW
On the NEW transmitter: hold down the but-
ton and
3
(x 1)
NEW
On the NEW transmitter: press and re-
lease the button (1 time);
A.5.2 - To memorise the transmitter buttons in "Mode II" ("Custom mode")
• Procedures A.5.2A and A.5.2.B memorise a single button on the new transmitter in Mode II; i.e. they associate with the button (chosen by the installer) one of the
commands in the motor's "list of commands" (for details on "Mode II" see section 3.4.1-B).
• Procedures A.5.2A and A.5.2.B memorise a single button. Repeat this operation to memorise another button.
9 – English
PRG
...
wait ...
count 2 movements;
PRG
release it after 5
count 2 movements.
seconds;
release it after 8 seconds;
count 3 movements (= transmitter memorised). If
the system makes 6 movements (= memory locked or
full, transmitter not memorised).
2
1
sec.
wait again...
count 2 more move-
ments;
3
2
OLD
On the OLD transmitter: press and
release the button (1 time);
2
OLD
On the OLD transmitter: press and release the but-
ton (3 times), provided the button is memorised.
end
3
2
PRG
2
release the button.
(x 1)
PRG
count 3 movements (= transmitter
memorised). If the system makes 6
movements (= memory locked or full,
transmitter not memorised).
3
(x 3)
end
3
Advertisement
