Table of Contents
Advertisement
Figure 4-2 Utility button
3. Select the [SHUT DOWN] button.
A message will appear: "The system will be shut down."
4. Press [YES] to proceed with the shut down; you will hear a beep as the system shuts down.
If you press [CANCEL] the system will not shutdown and it will return you to the Utilities screen.
NOTE: Refer to
Software Reset
NOTE: You must wait 15 seconds after power is removed from the system before powering the system
back up.
Login and Log off
This following sections apply if the system is configured for Login ability in the Service User Interface.
Refer to
Appendix B: Login Administration
Standard Login
The Login screen (Figure 4-3) appears when the system is started, reset, and after a user logs off. The
system may also be configured to display the Login screen if the system has been inactive for a specified
period of time (inactivity timeout).
Figure 4-3 Example login screen.
Definium 5000 X-Ray System
Operator Manual
(p. 4-6) for information about the Software Reset function.
for information on administering the login function.
5197809-1EN
Rev. 4 (13 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter 4: General Information
4-3
Advertisement
Table of Contents
