Table of Contents
Advertisement
Refresh
The Definium 5000 system may be configured to automatically refresh the Worklist with data from the
HIS/RIS on a regular basis (such as every 10 minutes). However, if your system does not automatically
refresh—or you want to refresh the list before the scheduled time—you are able to refresh the list
manually.
The Refresh feature also removes any filtering that has been applied. Refer to
information.
Manual Refresh
Follow this process to manually refresh the Worklist.
1. Press [REFRESH] on the Worklist.
The Worklist updates with HIS/RIS data and removes any filtering.
NOTE: Refresh does not remove locally added procedures.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
Auto Refresh
The Auto Refresh interval is set on the Preferences – Worklist screen in System Utilities. Refer to
Chapter 10: Set Preferences-Worklist
When the system auto refreshes, a message (Figure 5-7) appears: "Auto Refresh in progress. Please wait."
The message remains until the refresh process is complete.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
Figure 5-7 Auto refresh message
Definium 5000 X-Ray System
Operator Manual
(p. 10-13) for more information.
5197809-1EN
Rev. 4 (13 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter 5: Worklist
Filter List
(p. 5-8) for more
5-11
Advertisement
Table of Contents
