Table of Contents
Advertisement
4. Press [POWER OFF]. Hold the button for 5 seconds.
A message appears: "The system will be shut down."
NOTE: Refer to
Software Reset
5. Press [YES] to proceed with shut down.
[CANCEL] stops the system from shutting down and returns you to the Utilities screen.
NOTE: You must wait 15 seconds after power is removed from the system before powering the system
back up.
Login and Log off
This following sections apply if the system is configured for Login ability in the Service User Interface.
Refer to
Appendix B: Login Administration
Standard Login
The Login screen (Figure A2-5) appears when the system is started, reset, and after a user logs off. The
system may also be configured to display the Login screen if the system has been inactive for a specified
period of time (inactivity timeout).
Figure A2-5 Example login screen.
Follow this process to login to the system.
1. Start up the system or log off the previous user.
The Login screen appears.
2. Enter your Login Name, if necessary.
3. Type in your Password.
Definium AMX 700 X-Ray System
Operator Manual
(p. A2-8) for information about the Software Reset function.
for information on administering the login function.
5161515-1EN
Rev. 6 (10 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter A2: General Information
A2-5
Advertisement
Table of Contents
