Table of Contents
Advertisement
6.4
Basic functions
The system interface is a device that controls the heating sys-
tem. It can be used as a room thermostat and/or as a system
interface for monitoring the installation's operation and config-
uring the desired settings.
Manual room temperature adjustment
The operating mode of the zone associated with the device is
set to MANUAL (1).
Turn the selector to select the temperature value indicated on
the display using the movable cursor near the ring. Press the
selector to confirm.
The display shows the set temperature.
10°
5
°C
Room temperature adjustment in programmed mode
The operating mode of the zone associated with the device is
set to PROGRAMMED (2). During operation in scheduled pro-
gramming mode, the set room temperature can be changed
temporarily.
Turn the selector to select the temperature value indicated
using the movable cursor near the ring. Press the selector to
confirm.
The display shows the set temperature.
Turn the selector to set the time until which the change must
be maintained.
Press the selector to confirm. The (3) symbol appears on the
display.
The system interface will maintain the temperature value until
the set time, after which the pre-set room temperature is re-
stored.
10°
19
SALOTTO
5
°C
Fino alle 20:00
18:30 11/10/2020
21°
1
,5
19
°
,0
SALOTTO
30
50%
1,5 bar
Fig. 95
18:30 11/10/2020
21°
3
,5
°
2
,0
30
50%
1,5 bar
Fig. 96
Room temperature adjustment with AUTO function on
If the heating hot water temperature does not match the de-
sired value, it can be increased or decreased via the "Heating
Settings". The correction bar will appear on the display.
Press the selector to confirm, or press the back button to return
to the previous screen without saving.
6.5
Access to technical area
If the screensaver is on, press any button to access the main
page.
Simultaneously press the "Esc" and "Menu" buttons until "Insert
Code" appears on the display.
Turn the selector to enter the technical code (234) then press
the selector
to confirm; the display will show TECHNICAL
AREA.
– Language, date and time
– BUS network setting
– Zone mode
– Complete Menu
– Configuration wizard
– Service
– Faults
Turn the selector and select:
– BUS NETWORK SETTING
The display will show the list of devices connected within the
system:
– System interface (local)
– Energy Manager
– Zone Manager
To set the correct zone associated with the system inter-
face, turn the knob and select:
– System interface (local)
Press the OK button. Turn the knob and set the correct zone.
Press the OK button to confirm the setting.
Commissioning
51 / EN
Advertisement
Table of Contents
