Table of Contents
Advertisement
– To ensure correct operation of the kit, the unit must rest
on a base measuring at least 70 mm.
H≥70
mm
Condensate collection tray heating element
– Position the heating element (1) on the bottom of the
unit.
– Pass the power cables (2) of the heating element
through collar (3), cable hole (4) and collar (5).
– To connect the heating element electrically, refer to the
paragraph "Electrical connections".
Fig. 37
1
Fig. 38
5
2
3
4
Fig. 39
3.4
Installing the indoor unit
3.4.1
Place of installation
The indoor unit must be positioned in an occupied room to
ensure best performances.
To position the system, use the template provided and a spirit
level.
To avoid jeopardising the product's operation, the place of
installation must be adequate in relation to the threshold op-
erating temperature (min +5°C) and protected against direct
contact with atmospheric agents.
Minimum installation distances
350
mm
200
mm
i
If the DHW Expansion Vessel is installed, it is nec-
essary to leave a gap of at least 50 mm from the
rear wall.
Installation
350
mm
800
mm
Fig. 40
23 / EN
Advertisement
Table of Contents
