Table of Contents
Advertisement
– Pass the BUS cable (5) through the hole (6) on the elec-
trical panel.
5
6
– Open the internal panel (7) to access the housing (8)
of the interface.
4
46 / EN
Fig. 84
3
Fig. 85
– Open the flap (9) of the housing and insert the inter-
face (10).
– Close the flap (9).
– Once the interface has been installed on board, make
sure that the bus communication cable passes through
the hole (6) in the electrical panel, continues along the
panel (7) and is then connected to the terminal board
of the interface (11).
– Close the internal panel (7) and the front panel (2).
7
11
Electrical connections
10
9
Fig. 86
6
Fig. 87
Advertisement
Table of Contents
