Table of Contents
Advertisement
– Position the Light Gateway (5) in the housing (4) and
close the panel (3).
4
5
– Detach the clips (2) and open the cover (3).
3
2
48 / EN
3
Fig. 91
Fig. 92
– Pass the BUS cable (8) through the hole (9) on the elec-
trical panel.
8
9
– Connect the BUS cable (8) to the Light Gateway (5) re-
specting the polarity.
– Connect the second BUS cable (10) which must be
connected to the system interface.
10
– Install the system interface onto the device (refer to the
paragraph "On-board installation").
Electrical connections
Fig. 93
5
8
Fig. 94
Advertisement
Table of Contents
