Safety Instructions; General; Personnel Qualifications; Handling The Tester - Gossen MetraWatt PROFITEST H+E EASY CHECK Operating Instructions Manual

PROFITEST H+E EASY CHECK
1

Safety Instructions

1.1

General

• Carefully and completely read and adhere to these operating instructions.
The documents can be found at http://www.gossenmetrawatt.com. Retain
these documents for future reference.
• Carefully and completely read and adhere to the product documentation for the
tested/inspected AC charging point.
• Use only the specified accessories (included in the scope of delivery or listed as
options) with the tester.
• The tester and its accessories may only be used for the tests described in the
documentation for the tester. Safety of the operator, as well as that of the tester,
is only assured when it's used for its intended purpose.
1.2

Personnel Qualifications

• The tester is designed exclusively for use by laypersons as well as qualified elec-
tricians.
1.3

Handling the Tester

• Observe and comply with all safety regulations which are applicable for your
work environment.
• Only use the tester and its accessories within the limits of the specified technical
data and conditions (ambient conditions, IP protection code, measuring cate-
gory etc.).
• Do not use the tester in humid environments where condensation occurs, or in
environments with explosive gases.
• Never plug in wet connector plugs.
• Connect the test setups correctly in order to prevent injury to persons and dam-
age to the equipment.
• The USB socket must be covered when executing tests. Use the cover
attached to the tester for this purpose.
• Do not use the tester and its accessories after long periods of storage under
unfavorable conditions (e.g. humidity, dust or extreme temperature).
• Do not use the tester and its accessories after extraordinary stressing due to
transport.
• Do not expose the tester to direct sunlight.
1
Gossen Metrawatt GmbH