JVC HR-S3500U Instructions Manual page 54

POWER
Control Two JVC VCRs
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to B code
control signals. The remote control is preset to send A code
signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR to respond to B code
signals.
UNPLUG VCR'S POWER
CORD
Unplug from the AC outlet.
SET REMOTE CONTROL
CODE
While holding down A/B on the remote control, press
the NUMBER key "2" and then press STOP.
PLUGIN POWER CORD
Plug back in to the AC outlet.
TURN VCR POWERON
Press POWER on the remote.
Child Lock
This feature allows you to prevent the operation of the VCR.
TURN VCR POWER ON
Press POWER.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B (_' Step 2),
pressing "1" for A-code commands and "2" for B-code
commands.
ENGAGE CHILD LOCK
Press and hold POWER on the remote control until the
Child Lock indicator (.... ) appears on the front display
pane].
e Power turns OFF and the VCR cannot be turned on
from the POWER button on the front pane].
e ]_) cancel Child Lock, press and hold POWER on the
remote until the VCR turns on. During timer record-
ing, pressing TIMER also cancels Child Lock.
NOTES:
• When Child Lock is engaged, make sure to keep the remote
control out of the reach of children.
• Timer recording of programs that were previously set can be
performed while the Child Lock is engaged. The feature
remains in effect after the recording is finished.