JVC HR-S3500U Instructions Manual page 48

VIDE() OUT
Player Your VCR
S VIDE() OUT
S-Video cable
(supplied)
S VIDE() IN
AUDIO
OUT
io/Video cable
plied)
AUDI() IN
Recorder
VIDE() IN
Another VCR
Advantages Of S-VHS Editing
S-VHS allows you make high resolution vide() recordings
when dubbing from one VCR to another.
You can edit from VHS to S-VHS, from S-VHS to VHS, or
from S-VHS to S-VHS.
• From VHS to S-VHS (VIDEO-VIDEO connection): Record
VHS playback signals in the S-VHS mode. Although the
picture quality is inherently limited by the orignal VHS
source material, the edited tape has better picture quality
than those made by VHS-to-VHS editing.
• From S-VHS to VHS (VIDEO-VIDEO connection): Because
the picture quality of the source material is very high, time
edited tape has better picture quality than those made by
VHS-to-VHS editing.
• From S-VHS to S-VHS (S-VIDEO connection): A high
resolution copy is made of a high resolution original S-
VHS tape with minima[ picture degradation. This is the
preferred method of vide() dubbing.
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
Connect an AV cable between the player's VIDE() OUT
and AUDIO OUT connectors and the recorder's VIDE()
IN and AUDIO IN connectors.
• If using another VCR with an S-VIDEO input or
output connector, it is recommended to use time S-
VIDE() connection to minimize picture degradation
while editing.
• When using your VCR as time recorder and a monaural
VCR as the player, conned the player's AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
Insert the playback cassette into timeplayer and the
cassette to be recorded on into the recorder.
SETRECORDER'S INPUT
MODE
Set to "AUX". With this VCR, press the NUMBER key "0"
and/or CH to select depending on the connector being
used "L-I" for the rear AUDIO/VIDEO IN connector,
or "F-1" for the front AUDIO/VIDEO IN connector.
NOT[:
If you use your VCR as the recorder and have connected
another VCR to your VCR's S-VIDEO IN connecto_ you
need to set "REAR AUX INPUT" to "S-VIDEO" at the
Function screen. Follow steps 4 - 6 from the "Edit From
A C]_mcorder" section (;_" pg. 49 50).
ENGAGE TAPE DUBBING
MODE
Follow steps 12 14 from the "Edit From A Camcorder"
section (_' pg. 50).
STARTPLAYER
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to OFF before
pressing PLAY _" pg. 28).
START RECORDER
Set to its record nqode.
NOTES:
• Be sure to set "TAPE DUB MODE" back to "OFF" when you
finish editing.
• When "TAPE DUB MODE" is set to "ON"Active Video
(]dibrntion is deactiw_ted in order to provide better picture
quality edits.
• If you use an nuxiliary input to connect a cable box or DBS
receiver make sure that the correct input ("L-]", "F- ]" or "S-
VIDE()") is selected after you have finished editing _" step 6,
page 49).