JVC HR-S3500U Instructions Manual page 45

Auto SP-->EP Timer
If, when recording in SPmode, there is not enough tape to record
the entire program, the VCR automatica]]y switches to EP mode
to alk)w complete recording. This feature is especially handy
when recording a program of more than 2 hours in length.
For Example...
Recording a program of 140 milmutes ilm length onto a 120-
minute tape
Approximately 110 minutes Approximately 30 minutes
I sPtootle I EP N_ocle I
Total 140 minutes
Make sure you set "AUTO SP-_EP TIMER" to "ON" at the
Furlctiorl screen before the timer recording starts.
ACCESS MAIN MENU
SCREEN
Press MENU.
ACCESS FUNCTION SET
SCREEN
Move the highlight bar (arrow) to "FUNCTION SET" by
pressing CH A_" or SHUTTLE PLUS Av, then press OK
or SHUTTLE PLUS E>.
SELECTAUTO SP_EP
TIMER SET MODE
Move timehighlight bar
(arrow) to "AUTO SP_EP
TIMER" by pressing CH
AT or SHUTTLE PLUS
Av, then press OK or
SHUTTLE PLUS F>to set to
"ON".
FUNCTION
AUTO TIMER
OFF
SUPERIMPOSE ON
VIDEOSTABILIZER OFF
2ND AUDIORECORD OFF
AUDIOMONITOR HI-FI
NEXT PAGE
RETURN TO NORMAL
SCREEN
Press MENU.
Auto Timer
When the Auto Timer is set to ON time timer is automatically
engaged when time VCR's power is turned off. It is automatically
disengaged when the VCR is powered back on.
ACCESSMAIN MENU
SCREEN
Press MENU.
ACCESS FUNCTION SET
SCREEN
Move the highlight bar (arrow) to "FUNCTION SET" by
pressing
CHAT
or SHUTTLE
PLUS
Av, then press OK
or SHUTTLE PLUS E>.
SELECTAUTO TIMER SET
MODE
Move time highlight bar
(arrow) to "AUTO TIMER"
by pressing CH_,T or
SHUTTLE
PLUS
Av, then
press OK or SHUTTLE
PLUS E>to set to "ON" or
"OFF".
FUNCTION
' 0 " 0
SUPERIMPOSE ON
AUTO SP_EP TIMER OFF
VIDEOSTABILIZER OFF
2ND AUDIO RECORD OFF
AUDIOMONITOR HI-Fi
NEXTPAGE
RETURNTO NORMAL
SCREEN
Press MENU.
NOTE:
For safety, when AUTO TIMER is set to "OFF", ,311other VCR
functions are disabled while the Timer mode is engaged. To
disengage the timer, press TIMER.
NOTES:
• If you have programmed the VCR to timer-record 2 or more
programs, the second program and those thereafter may not
fit on the tape if you set the Auto SP-_EP Timer mode to
"ON". In this case, make sure the mode is not engaged, then
set the tape speed manually during timer programming.
• In order to ensure that the recording fits on the tape, this
feature may leave a slight non-recorded section at the end of
the tape.
• There may be some noise at the point on the tape where the
VCR switches from SP to EP mode.
• The Auto SP-_EP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will work with the
following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.