JVC HR-S3500U Instructions Manual page 34

Recorclin
Features
DISPLAY
C.RESET
Record one Program While
Watching Another
ENGAGE TV MODE
During recording...
• Press TV/VCR. TimeVCR's VCR indicator goes out. (if
you are using time RFconnection (_' pg. 6) to view
the output from your VCR, the TV broadcast being
recorded disappears.)
e if you are using the AV connection (:_' pg. 6) to view
the output from your VCR, change the TV's input
mode from AV to TV.
SELECTCHANNEL FOR
VIEWING
Use the TV's channel selector to set the channel you
want to watch.
DispLay Elapsed Recording
Time
RESET COUNTERTO ZERO
Before recording starts, press C.RESET. The counter
resets to zero and displays the exact elapsed time as the
tape runs.
DISPLAY ELAPSEDTIME ON
SCREEN
During recording, press OSD at any time to see the
e]apsed time.
A]] indications corresponding to the current status of time
VCR are displayed for 5 seconds. Time counter display
remains on the screen indicating the elapsed time.
Press OSD again to remove the disp]ay.
e Make sure "SUPERIMPOSE" is set to "ON" (:_' pg. 28).
o The indications are not recorded.
• Press DISPLAY to change to the COUNT display if
"REMAIN" is displayed.
Display Tape Remaining Time
DISPLAY COUNTER
INFORMATION
Press OSD.
All indications corresponding to the VCR's current
status are displayed for 5 seconds. Time counter display
remains on the screen indicating the elapsed time.
DISPLAYTAPE REMAINING
TIME
Press DISPLAY until "REMAIN" appears on screen. Time
approximate tape remaining time appears on the TV
screen and also on the VCR display panel with a "_"
indicator.
e Time tape remaining time is calculated based on the
tape speed (SP or EP) being used. Time indicated
remaining time is on]y an estimate.
e Press DISPLAY to change the on-screen disp]ay from
REMAIN to COUNT and vice versa; and to show
counter reading, channel number, clock time or tape
remaining time on the front disp]ay panel. Then
channel number will not be displayed when the VCR
is playing a tape.
EXITTHE DISPLAY
Press OSD again.
NOTES:
• "SUPERIMPOSE" must be set to "ON", or the on-screen
display will not appear (_ pg. 28).
• Near the beginning of the tape, the tape remaining estimate
may be inaccurate. However, the estimate becomes more
accurate as the tape comes closer to the end.
• Depending on the type of tape used, the tape remaining time
reading may not appear right away, or may not be correct. "- -:- -"
may sometimes appear, or the display may brink on occasion.
• The tape remaining time indication is not accurate when
using VHS-C tapes with VHS-C adaptec