Onboard Serial Port 1/Port 2
This item allows you to determine access onboard serial port 1/port 2
controller with which I/O addresses.
The Choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
Onboard Parallel Port
Select a logical LPT port name and matching address for the physical
parallel (printer) port.
The choice: 378H/IRQ7, 278H/IRQ5, 3BCH/IRQ7, Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel port. Select Compatible
or Extended unless you are certain both your hardware and software
support EPP or ECP mode.
The choice: SPP, ECP + EPP1.7, EPP1.7 + SPP, EPP1.9 + SPP, ECP,
ECP + EPP1.9, and Normal.
ECP Mode Use DMA
Select a DMA channel for the port. Choices are 3, 1.
4.2.10 Password Setting
When you select this function, a message appears at the center of the
screen:
ENTER PASSWORD:
Type a password, up to eight characters, and press the Enter key.
Typing a password clears any previously entered password from CMOS.
Now the message changes:
CONFIRM PASSWORD:
Again, type the password and press the Enter key.
To clear the password, simply press the Enter key when asked to enter a
password. Then the password function is disabled.
4-32