Installing A Dimm - FlyTech 3000 Series User Manual

2.4.4 Installing a DIMM

The main board contains two DIMM sockets. You can insert one DIMM
or two DIMMs. However, it is recommended that you use two DIMMs of
the same type and same access speed.
ê Caution
To avoid generating static electricity and damaging the DIMM, ground
yourself by touching a grounded metal surface or using a ground scrap
before you touch the DIMM.
Do not touch the connector of the DIMM. Dirt may cause a malfunction.
Follow these steps to install the DIMMs:
1. Hold the DIMM with its notch to the front side of the Book PC and
insert it completely into the socket. A DIMM should be inserted into the
inner socket first. Guiding the hole at each end of the DIMM over the
retaining post at each end of the DIMM socket.
Pull
2. If you install two DIMMs, install the second DIMM using the same
procedure as above.
Note:
If DIMM does not go in smoothly, do not force it. Pull it all the way out and
try again.
ê Caution
Make sure the DIMM is properly installed and locked by the tabs on both
sides of the socket.
Removing a DIMM:
To remove the DIMM, use your fingers or a small screwdriver to carefully
push away the plastic tabs that secure the DIMM at each end. Lift it out
of the socket.
2-16
Pull