Table of Contents
Advertisement
Power Management setup
This category determines how much power consumption for system after
selecting below items. Default value is Disable.
PNP/PCI Configuration
This category specifies the value (in units of PCI bus clocks) of the
latency timer for this PCI bus master and the IRQ level for PCI device.
Load BIOS defaults
BIOS defaults indicates the most appropriate value of the system
parameter which the system would be in minimum performance.
Load setup defaults
Setup defaults indicates the values required by the system for the
maximum performance.
Integrated Peripherals
Change, set, or disable on board supers I/O function.
Supervisor password & Password setting
Change, set, or disable password. It allows you to limit access to the
system and Setup, or just to Setup.
IDE HDD auto detection
Automatically configure hard disk parameters.
Save & exit setup
Save CMOS value changes to CMOS and exit setup.
Exit without save
Abandon all CMOS value changes and exit setup.
4-5
Advertisement
Table of Contents
