Setting Jumpers And Dip Switches - FlyTech 3000 Series User Manual

2.4.2 Setting Jumpers and DIP Switches

There are jumpers and DIP switches on the board of Book PC 3000.
You can set them to control how the system operates.
For three-pin jumpers, the jumper setting is 1-2 when the jumper
connects pins 1 and 2. The setting is 2-3 when pins 2 and 3 are
connected. You see a 1 and a 3 printed on the circuit board to identify
these pins. Also, one of the lines surrounding jumpers is thick, which
indicates pin NO.1.
To move a jumper from one position to another, use needle-nose pliers or
tweezers to pull it off the pins and move it to the desired position.
ê Caution
Be careful not to bend the jumper pins or damage any components on
the board.
Do not change settings for jumpers and DIP switches not covered in this
manual.
2-9