Table of Contents
Advertisement
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input / Output) fields let you set a PIO
mode (0-4) for each of the four IDE devices that the onboard IDE
interface supports.
Modes 0 through 4 provide successively increased performance. In
Auto mode, the system automatically determines the best mode for each
device.
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver
(Windows 95 OSR2 or a third-party IDE bus master driver). If your hard
drive and your system software both support Ultra DMA/33, select Auto to
enable BIOS support.
The Choice: Auto, Disabled
On-Chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with support
for two IDE channels. Select Enabled to activate each channel
separately.
USB Keyboard support
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.
The Choice: Enabled, Disabled.
Onboard FDD Controller
This should be enabled if your system has a floppy disk drive (FDD)
installed on the system board and you wish to use it. Even when so
equipped, if you add a higher performance controller, you will need to
disable this feature.
The Choice: Enabled, Disabled.
4-31
Advertisement
Table of Contents
