Set Up Wideband For An Analog Headset - Cisco 8811 User Manual

Set Up Wideband for an Analog Headset

• Samsung
Other mobile devices are supported but there may be instances of incompatibility where they will not get
Note
charged.
When charging your mobile device using your Cisco IP Phone, the following conditions apply:
• When you plug in a tablet, it takes about 3 seconds for the charging to begin. When it gets fully charged
• In the PoE mode, when you plug-in a tablet, it does not display the charging icon and the battery capacity
• If the battery capacity of your mobile device is lower than 90% when you plug it in, you will notice that
• If you unplug your tablet and immediately plug-in a USB headset to the tablet, there will be a delay of
• When more than one Cisco IP Phone 8800 Key Expansion Module is attached, back USB port cannot

Set Up Wideband for an Analog Headset

Procedure
Step 1
Press Applications
Step 2 Use the Navigation cluster and Select button to scroll and select Accessories.
A list of phone accessories displays.
Step 3 Select Analog Headset and press Setup.
The phone screen displays the wideband status for the analog headset.
Cisco IP Phone 8811, 8841, 8845, 8851, 8851NR, 8861, and 8865 User Guide for Cisco Unified Communications
Manager 11.0
128
REVIEW DRAFT - CISCO CONFIDENTIAL
◦ iPAD mini
◦ iPhone 4 and iPhone 5 series
◦ Tablet
◦ Note 2 and Note 3 series
◦ Galaxy S4 series
or nearly fully charged, the charging icon does not display and the battery capacity may decrease over
time.
Note You can force the charging icon to display by unplugging and re-plugging in your device.
may decrease over time.
charging starts immediately, stops for 2 seconds, and then resumes.
3 seconds before the phone recognizes the USB headset.
fast-charge the device.
.
Accessories