On-Board Computer Error; Lighting Does Not Work - Bosch KETTLER Traveller E-Silver 7 RT Manual

Symptom Cause
There is an unusual smell.
Fumes are emitted from
the battery.
Table 40: Error solution for battery
9.1.5

On-board computer error

Symptom Cause
The battery charge level may be
insufficient.
Is the power switched on?
Is the battery charged?
No data is shown on the
monitor if you press the
On-Off button (battery).
Is the connector fitted to the power
cable correctly?
A component may be connected which
the system is unable to recognise.
The gear level is not
The gear level is only shown if the
shown on the display
electronic gear shift is used.
screen.
The product is designed in such a way
The settings menu cannot that the settings menu cannot be
be opened while you are opened if the system detects that
riding. someone is riding the pedelec. This is
not a malfunction.
The time display is The battery in the on-board computer
flashing "0:00". has come to the end of its service life.
Table 41: Display error solution
9.1.6

Lighting does not work

Symptom Cause
The front light or rear light
The basic settings in the electric drive
does not go on, even
system have probably been configured
when the switch is
incorrectly. The light is defective.
pressed.
Table 42: Error solution for battery
MY21K01 - 32_1.0_24.09.2020
All manuals and user guides at all-guides.com
Remedy
1 Remove the battery from the pedelec immediately.
2 Contact the fire service.
3 Observe all the warnings in Section 2 Safety.
1 Remove the battery from the pedelec immediately.
2 Contact the fire service.
3 Observe all the warnings in Section 2 Safety.
Remedy
1 Charge the battery.
2 Press the On-Off button (battery) to switch the power on.
3 If the battery is fitted to the pedelec and is being charged, it
cannot be switched on. Interrupt charging process.
4 Check that the power cable connector has not been
disconnected.
5 Contact your specialist dealer if this is not the case.
6 Contact your specialist dealer.
1 Check whether the power cable plug has been disconnected.
2 Contact your specialist dealer if this is not the case.
1 Stop the pedelec.
2 Change settings when stationary only.

Replace the on-board computer battery.
Remedy
1 Take pedelec out of service immediately.
2 Contact your specialist dealer.
Troubleshooting, fault clearance and repair
110