Table of Contents
Advertisement
6.5.6.4 Adjusting the RockShox fork steel
suspension
Only applies to pedelecs with this equipment
The external spring preload setting compresses or
decompresses the spring without changing
deflection.
Figure 78: Screwing and unscrewing the pre-tension
adjustment ring.
Screw in the Sag setting wheel clockwise to
increase pre-tensioning and reduce the sag.
Unscrew the Sag setting wheel in an anti-
clockwise direction to decrease pre-tensioning
and increase the sag.
The spring pre-tensioning setting can be used to
finely adjust the sag; however, pre-tensioning
does not change spring stiffness and is not
suitable to substitute the correct compression
spring rate.
MY21K01 - 32_1.0_24.09.2020
All manuals and user guides at all-guides.com
6.5.6.5 Adjusting the RockShox air suspension
Only applies to pedelecs with this equipment
When adjusting the sag, ensure that all dampers
are in the open position, i.e. turned anti-clockwise
until they stop.
The pressure is to be measured at an ambient
temperature of 21 to 24 °C.
1 The air valve is located under a cover on the
head of the shock absorber. Unscrew the air
valve cap in an anti-clockwise direction.
Figure 79: Removing the cover (1) from the air valve (2)
2 Place a high-pressure pump on the valve.
3 Pump the suspension fork to the required
pressure. Observe the levels in the air
pressure table.
Rider weight
RockShox Lyrik SELECT
< 55 kg
< 55 psi
55 - 63 kg
55 - 65 psi
63 - 72 kg
65 - 75 psi
72 - 81 kg
75 - 85 psi
81 - 90 kg
85 - 95 psi
90 - 99 kg
95 - 105 psi
> 99 kg
105 + psi
Max. pressure
163 psi
Table 35: Filling pressure table for RockShox LYRIK SELECT
air fork
4 The recommendations for air pressure in the
front wheel suspension are also indicated on
the rear of the fork and can be found at
https://trailhead.rockshox.com/en.
5 Remove the high-pressure pump.
Operation
1
2
< 3.8 bar
3.8 - 4.5 bar
4.5 - 5.2 bar
5.2 - 5.9 bar
5.9 - 6.6 bar
6.6 - 6.8 bar
6.8+ bar
11.2 bar
64
Advertisement
Table of Contents
