Table of Contents
Advertisement
7.4.1.4 Checking and adjusting the tyre
pressure – Presta valve
Only applies to pedelecs with this equipment
1 Unscrew and remove the
2 Open the knurled nut
3 Carefully apply the bicycle
4 Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
5 Correct the tyre pressure as per the
specifications on the tyre.
6 Remove the bicycle pump.
7 Tighten the knurled nut with your fingers.
8 Screw the valve cap tight.
9 Screw the rim nut gently against the rim with
the tips of your fingers.
7.4.1.5 Checking and adjusting the tyre
pressure – Schrader valve
Only applies to pedelecs with this equipment
It is recommendable to use a
bicycle pump with a pressure
gauge. The operating
instructions for the bicycle
pump must be adhered to.
1 Unscrew and remove the
valve cap.
1
2 Attach the bicycle pump.
3 Pump up the tyre slowly
and pay attention to the tyre pressure in the
process.
The tyre pressure has been adjusted as per the
specifications.
4 Remove the bicycle pump.
5 Screw the valve cap tight.
6 Screw the rim nut (1) gently against the rim
with the tips of your fingers.
MY21K01 - 32_1.0_23.09.2020
All manuals and user guides at all-guides.com
It is recommendable to use
a bicycle pump with a
pressure gauge. The
operating instructions for
the bicycle pump must be
adhered to.
valve cap.
around four turns.
pump so that the valve
insert is not bent.
7.4.2
Brake system
CAUTION
!
Crash caused by brake failure
Worn brake discs and brake linings, as well as a
lack of hydraulic fluid in the brake cable, reduce
the braking power. This may cause a crash with
injuries.
Check the brake disc, brake linings and
hydraulic brake system on a regular basis.
Contact your specialist dealer if any of these
components have become worn.
The maintenance interval for the brake depends
on the weather conditions and how frequent the
bicycle is used. If the pedelec is used under
extreme conditions such as rain, dirt or high
mileage, maintenance must be performed more
frequently.
7.4.3
Checking the brake linings for wear
Check brake linings after brake has been fully
applied 1,000 times.
1 Check that the brake linings are no less than
1.8 mm wide at any point and no less than
2.5 mm between the brake lining and
supporting plate.
2 Push brake lever and hold. In doing so, check
the transport safety wear gauge can fit
between the brake lining supporting plates.
The brake linings have not reached their wear
limit. Contact your specialist dealer if any of
these components have become worn.
Cleaning and servicing
99
Advertisement
Table of Contents
