Suspension Seat Post; Axle With Quick Release - Bosch KETTLER Traveller E-Silver 7 RT Manual

8.1.3

Suspension seat post

Only applies to pedelecs with this equipment
Maintenance intervals
by.schulz seat post
Check all screws for correct tightening

torques for:
G1 and G2
Suntour suspension seat post

Maintenance 1
RockShox suspension seat post
Venting of remote control lever and/or
maintenance of lower seat post unit for:

Reverb™ A1/A2/B1, Reverb Stealth A1/A2/B1/
C1*, Reverb AXS™ A1*
Venting of remote control lever and/or
maintenance of lower seat post unit for:

Reverb B1, Reverb Stealth B1/C1*, Reverb
AXS A1*
Complete maintenance of seat post for:

Reverb A1/A2, Reverb Stealth A1/A2
Complete maintenance of seat post for:

Reverb B1, Reverb Stealth B1
Complete maintenance of seat post for:

Reverb AXS A1*, Reverb Stealth C1*
All other suspension seat posts

Maintenance
Special tools, special lubricants and knowledge of
suspension components are required to service
and repair suspension seat posts.
The suspension seat post may be damaged if
procedures are not followed as described. Only
specialist dealers may carry out maintenance on
the suspension seat post.
MY21K01 - 32_1.0_24.09.2020
All manuals and user guides at all-guides.com
8.2
Crash caused by unfastened quick
release
A faulty or incorrectly installed quick release may
After 250 km and
become caught in the brake disc and block the
every 1,500 km
wheel. This will cause a crash.
 Install the front wheel quick release lever on
every 100 hours
Crash caused by faulty or incorrectly
installed quick release
every 50 hours
The brake disc becomes very hot during
operation. Parts of the quick release may become
damaged as a result. The quick release comes
every 200 hours
loose. This will cause a crash with injuries.
 The front wheel quick release lever and the
every 200 hours
every 400 hours
Crash caused by incorrectly set clamping
force
every 600 hours
Excessively high clamping force will damage the
quick release and cause it to lose its function.
every 100 hours
Insufficient clamping force will cause a
detrimental transmission of force. The
suspension fork or the frame may break. This will
cause a crash with injuries.
 Never fasten a quick release using a tool (e.g.
 Only use the clamping lever with the specified

Axle with quick release

CAUTION
!
the opposite side to the brake disc.
brake disc must be situated on opposite sides.
hammer or pliers).
set clamping force.
Maintenance
104