Table of Contents
Advertisement
2 Push in the quick release until you can hear a
click. Make sure that the flange is extended.
Figure 58: Pushing the quick release in
3 Adjust tensioning with half-open clamping
lever until the flange reaches the fork end.
Figure 59: Adjusting the clamping
4 Fully close the quick release. Check that the
quick release is firmly in place and adjust it on
the flange if necessary.
The lever is secured.
Figure 60: Closing the quick release
MY21K01 - 32_1.0_23.09.2020
All manuals and user guides at all-guides.com
5.4.2
5.4.2.1
Only applies to FOX forks with 15 mm screw-on axle
The same procedure is used for installing both the
15 x 100 mm and 15 x 110 mm quick releases.
1 Place the front wheel in the fork ends of the
Figure 61: Pushing the quick release in
2 Open the axle lever.
3 Turn the axle five to six complete revolutions
4 Close the quick release lever. The lever must
5 The lever must be 1 to 20 mm in front of the
Figure 62: Spacing between lever and fork leg
The quick release must be adjusted if the
Installing the wheel in the FOX fork
Quick release (15 mm)
fork. Push the axle through the fork end on the
non-drive side and hub.
clockwise into the axle nut.
be tensioned to the point that it leaves a mark
on your hand.
fork leg in the closed position.
1-20 mm
lever is tensioned inadequately or too strongly
when closed in the recommended position
(1 to 20 mm in front of the fork).
Assembly
48
Advertisement
Table of Contents
