Table of Contents
Advertisement
o
BLC: If enabled, the auto exposure will activate according to the
scene so that the object of the image in the darkest area will be
seen clearly.
•
Antiflicker:
o
Off: Disables the anti-flicker function. This is used mostly in
outdoor installations.
o
50Hz: Reduces flicker in 50Hz lighting conditions.
o
60Hz: Reduces flicker in 60Hz lighting conditions.
•
Smart IR: Choose "ON" or "OFF". This function can effectively avoid
image overexposure and underexposure by controlling the brightness
of the IR lights according to the actual conditions to make the image
more realistic. Please enable it as needed.
•
White Balance: Adjust the color temperature according to the
environment automatically.
•
Day/Night Mode: Choose "Auto", "Day", "Night", or "Timing".
o
Sensitivity: Set the general amount of environmental light that is
required to trigger switching Day/Night modes.
o
Delay Time (Seconds): Set the amount of time that the camera
will delay switching between Day/Night modes when triggered.
•
Exposure Mode: Choose "Auto" or "Manual". If "Manual" is chosen,
the digital shutter speed can be adjusted.
•
Gain Mode: Choose "Auto" or "Manual". If "Auto" is selected, the
gain value will be automatically adjusted according to the actual
situation. If "Manual" is selected, the gain value shall be set
manually. The higher the value is, the brighter the image is.
•
Gain Limit: Set the maximum digital gain level for the camera
image. There are two separate configurations for Auto or Manual
Gain Modes.
•
Frequency: 50Hz and 60Hz can be optional.
•
Infra-red Mode: Choose "Auto", "ON" or "OFF".
•
Corridor Pattern: Corridor viewing modes can be used for
situations such as long hallways. 0, 90, 180 and 270 are available.
The default value is 0. The video resolution should be 1080P or
below if this function is used.
•
Image Mirror: Turn the current video image horizontally.
•
Image Flip: Turn the current video image vertically.
5.1.2 Video Configuration
Go to Setup>Camera >Video interface as shown below. In this interface, set the
11
Advertisement
Table of Contents
