Table of Contents
Advertisement
Programming the Control Panel
Programming Text
Text is programmed in a similar way to mobile phones. Characters
are selected by pressing the corresponding key the appropriate
number of times (to select a character on the same key, press
to move the cursor along) i.e. to spell the word PIR, type
7444777.
The table below shows the keys to use and the characters that are
assigned to them:
Key
.
,
1
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
T
U
V
W
X
Y
0
Advance Cursor
Backspace
Upper/Lower Case & Numerical
Accept New Text
Whenever text is programmed, the ''
option must be used to send the programmed text, to all
keypads connected to the system (see page 36).
Programming Zone Text
Up to 10-characters of descriptive text can be programmed for
each zone i.e. Front Door, Hall, Bedroom 1, etc.
From the Programming Menu, enter
look like this.
Select characters by pressing the corresponding key the
appropriate number of times (to select a character on the same
key, press
to move the cursor along). Press
system will chime to confirm that the Text has been accepted. The
system will then automatically revert to the Programming Menu.
36
-
Text
'
#
&
+
-
/
2
3
4
5
6
S
7
8
Z
9
. The display will
Programming User Name Text
Up to 8-characters of descriptive text can be programmed for each
user i.e. John, Mike, Susan, etc.
From the Programming Menu, enter
look like this.
Select characters by pressing the corresponding key the
appropriate number of times (to select a character on the same
key, press
system will chime to confirm that the Text has been accepted. The
:
system will then automatically revert to the Programming Menu.
Banner Text
This 16-character message is displayed above the time and date
whenever the control panel is set or unset.
From the Programming Menu, enter
look like this.
Select characters by pressing the corresponding key the
appropriate number of times (to select a character on the same
key, press
system will chime to confirm that the Text has been accepted. The
system will then automatically revert to the Programming Menu.
Broadcast Text
This option sends any programmed text, to all keypads connected
to the system (must be done whenever new text is programmed).
From the Programming Menu, enter
look like this.
Press
. The system will chime to confirm that the text has
been broadcast to the other keypads. The system will then
automatically revert to the Programming Menu.
Default Text
This option will default all of the programmable text values.
. The
From the Programming Menu, enter
look like this.
Press
. The system will chime to confirm that the text has
been defaulted. The system will then automatically revert to the
Programming Menu.
Veritas R8 Plus & Excel Installation Manual
to move the cursor along). Press
to move the cursor along). Press
. The display will
. The
. The display will
. The
. The display will
. The display will
INS045-14
Advertisement
Table of Contents
