Security control panels with integrated communicator (80 pages)
Summary of Contents for Texecom Veritas R8Plus
Page 1
400 THANK YOU FOR VOTING TEXECOM MASTER USER GUIDE For Service Call Scorpion Group Security - 01452 525397...
Page 2
Assigning Access Codes Master User Guide Master User Guide Assigning Access Codes The control panel allows up to eight users to operate the alarm system, each user is assigned an “Access code”, “Access Level” and “User Number”. The figure below shows an example of users assigned to a typical alarm system: 4...7 User Number:1...
Page 3
Master User Guide Assigning Access Codes There are eight possible User Access Levels: User A User may set, unset, silence an alarm and reset the system. In addition a User can test the system outputs, perform a walk test and view the event log.
Page 4
Assigning Access Codes Master User Guide 1. When a cleaner is Setting the system the Cleaner Suite zones will flash indicating that they are currently omitted but are about to be re-included. Any other omitted zones (e.g. if the system was previously part set rather than full set) will also flash but will NOT be included.
Master User Guide Programming Access Codes Programming Access Codes Each user has a programmable 4 digit Access code which the user enters in order to operate the alarm system. &- Changing Your Own Access Code Every user has the ability to change their own 4 digit Access code, as follows: From the Unset State: 1) Enter your existing Access code...
Page 6
Programming Access Codes Master User Guide From the Unset State: 1) Enter your Access code '''' 2) Press PROG to access the Programming Menu 3) Enter 69 to select the View Your User Number option &0 4) The zone light corresponding to your User Number will illuminate 5) Press RESET, the system will return to the Programming Menu 6) Press RESET to revert to the unset state Changing Access Levels...
Page 7
Master User Guide Programming Access Codes Displaying Your Access Level Every user may view their own Access Level From the Unset State: 1) Enter your Access code '''' 2) Press PROG to access the Programming Menu 3) Enter 79 to select the View Your Access Level option 4) The zone light corresponding to your Access Level will illuminate 5) Press RESET, the system will return to the Programming Menu 6) Press RESET to revert to the unset state...