Programming The Control Panel; Introduction; The Programming Menu; Programming With An Lcd Keypad - Texecom Veritas R8 Plus Installation Manual

Veritas R8 Plus & Excel Installation Manual

4. Programming the Control Panel

Introduction

Programming is usually unnecessary as the factory settings have
been carefully selected to suit most installations without alteration.
However all functions are fully programmable for Complete
Control.

The Programming Menu

The Programming Menu can only be accessed when the control
panel is unset.
The display will normally look like this:
Z on es
U n set
1 2 3 4 5 6 7 8
T am p er
Enter your 4-digit Engineer code (factory set to
The display will look like this:
Z on es
U n set
1 2 3 4 5 6 7 8
T am p er

If no keys are pressed, the display will revert back to normal
after 16 seconds.
Press  , the display will look like this:
Z on es
U n set
1 2 3 4 5 6 7 8
T am per
The various programming options are then selected by entering a
2-digit Option code  . The Programming Procedure then
depends upon the programming option selected as detailed in the
following sections. On completion, each programming option
reverts to the Programming Menu, allowing other programming
options to be accessed. To exit the Programming Menu press

, the system will revert to unset.

To abort programming at any stage (and preserve the
original setting) press
Programming Menu.
24 Hour zones (Fire, PA and Tamper) are disabled when the
Programming Menu is accessed via an Engineer code.
To omit zones, set chime or change the User code, refer to
the User Guide.
The system programming is retained even in the event
of complete loss of power.
INS045-14
 -









, the system will revert to the


Programming With an LCD Keypad

There are two ways to select options whilst in the Programming
mode:
1. Select an option directly by entering a 2-digit Option code



2. Using the
options and then pressing
menu options.

).

Available LCD Menus

There are two ways to select options whilst in the Programming
mode:


Programming the Control Panel
.
All of the programming examples shown in this section
use this method of programming.

key to scroll up and down through the menu

Wherever a symbol appears on the display, the

key can be used to search through the various

menu options. The or

used to select the displayed option.
















































or to access the
key can then be

19