Sharp MultiSync ME652 User Manual page 37

Set a password for the monitor
This step is only required if you want to change the password.
1. Using the remote control, navigate to [Protect] then to [Security Settings]. Select [Password], press OK.
2. Input an admin password and press [OK]. Then you can set other options in [Security Settings].
3. To change the password, under [Change the admin password], enter the current password and press [OK].
4. Input a [Enter new password] field and then input it again in the [Confirm new password] field.
5. The new password is immediately saved.
Enable password security
1. Using the remote control, navigate to [Protect] then to [Security Settings].
2. Select the options you want to use:
• [Lock Admin Setting] – the password is required to enter the [Administrator Settings] menu.
• [Start-Up Lock] – the password is required when turning on the monitor from the main power switch.
When this option is selected the password is only required on power cycle using the main power switch or after power
failure. This option does not prompt for a password when using the remote control POWER ON and STANDBY buttons
or the ⏻ button on the rear side of the monitor.
• [Control Lock] – the password is required to use any of the remote control buttons or buttons on the monitor.
TIP:

The settings are enabled after OSD menu is closed and the specified time has passed that you set in [OSD Time].
nLocking the Button Controls
The lock settings prevent the monitor from responding to button presses on the IR remote control or the rear side of the monitor.
When locking the button controls, some buttons can be configured to remain unlocked for users to adjust the settings. Locking
and unlocking the button controls do not require a password.
English−37