Schedule; Network - Sharp Multisync Me652 User Manual

Schedule

Schedule
Power On Schedule
Add Power On Schedule
Power Off Schedule
Add Power Off Schedule
Reboot Schedule
Add Reboot Schedule
Schedule List
Reset

TIP: • The [Date & Time] needs to be set before adding schedules.

• Each schedule must be set at an interval of 5 minutes or more.

• Up to 15 different schedules can be created.

Network

Network
Ethernet
Ethernet
Obtain IP Address
Automatically
IP Address
Default Gateway
Netmask
DNS 1
DNS 2
MAC Address
Proxy
Ping
IP Address
Execute
Network Settings
HTTP Server
AMX
Turns the monitor power on at the specified time. See
Settings for configuring the power on schedule for the monitor.
Turns the monitor power off at the specified time.
Settings for configuring the power off schedule for the monitor.
Restarts the Android system at the specified time.
Settings for configuring when to reboot the Android system.
Shows a list of schedules configured for the monitor.
Schedules can be enabled, disabled, edited, or deleted from the list.
Resets all schedule menu settings back to factory setting.
Sets whether or not to use a LAN terminal.
Configures the IP address and network information automatically or manually.
Sets whether or not to obtain the IP address automatically from the DHCP server.
When manually setting the IP address and other network settings, contact the network administrator for
the required information.
Enter the IP address for the monitor to use on the connected network when not using [Obtain IP Address
Automatically].
Enter the gateway for the network when not using [Obtain IP Address Automatically].
Enter the subnet mask data for the network when not using [Obtain IP Address Automatically].
Enter the primary DNS server settings for the network when not using [Obtain IP Address Automatically].
Enter the secondary DNS server settings for the network when not using [Obtain IP Address
Automatically].
Shows the monitor's [MAC Address].
Sets the proxy server settings of the network connected to the monitor.
None: No set the proxy.
Manual: Set the host name, port number, and address.
Proxy Auto-Config: Set the URL that the proxy PAC file is on.
Confirm successful connection with the network by communicating with a preset IP address.
Sets an [IP Address] for sending [Ping].
Checks a reply can be sent to the monitor or not from the [IP Address] by sending [Ping].
Sets whether or not to use HTTP server functions.
To turn on or off for the detection from AMX Device Discovery when connecting to a network supported by
an AMX's NetLinx control system.
page
English−58
35.