Basic of Assembly
4
Attachment of Side feed assy
1. Attach the side feed assy to the arm bed with the two screws (taptite, bind S M4x10).
2. Set the boss of side feed assy to the side feed adjust plate, set the washer to the side feed adjust plate,
align the notch of spring plate B with the boss, and attach the spring plate B to the side feed adjust plate
with the screw (screw, bind M3x6).
3. Clip the each lead wire together.
*Key point
• Refer to
"Wiring of Thread cutter module / Feed module / Side feed
Washer
Spring plate B
Screw, bind M3x6
Taptite, Bind S M4X10
Screw, Bind M3X6
Lower driving mechanism
Clip
Taptite,
bind S M4x10
2 - 51
assy".
Side feed adjust plate
Side feed assy