Baby Lock BLDY Service Manual page 268

Application of
Assembly
19
Attachment of Camera relay PCB assy
1. Attach the CMR holder ADJ to the CMR holder base, and then tighten the screw (bolt, socket (S/P
washer) M3x6) temporarily.
*Key point
• Check that the boss part of the CMR holder ADJ engaged with the positioning hole of the CMR holder base.
• Fully tighten the screw after performing
2. Insert the CMR ADJ screw into the washer plain S 3 and the CMR ADJ pin, and then secure them with
the retaining ring E2. Insert the pin of CMR ADJ pin to the holes of the CMR holder ADJ and the CMR
holder base, and then tighten the CMR ADJ screw temporarily.
*Key point
• Fully tighten the CMR ADJ screw after performing
3. Attach the CMR spring plate to the CMR holder ADJ with the screw (screw, pan (S/P washer) M3x6).
4. Set the camera module and the CMR cover cap to the CMR cover, and then attach them to the CMR
holder ADJ with the screw (screw, pan (S/P washer) M3x8).
*Key point
• Insert the tab of the CMR holder ADJ into the positioning hole of CMR cover.
Bolt, Socket (S/P washer) M3X6
Screw, Pan (S/P washer) M3X6
Screw, Pan (S/P washer) M3X8
CMR holder base
CMR cover cap
CMR cover
Needle-presser module
"Adjustment of Camera
Screw, pan (S/P washer) M3x6
CMR spring plate
Screw, pan (S/P washer) M3x8
3 - 170
angle".
"Adjustment of Camera angle".
Retaining ring E2
CMR ADJ pin
Washer plain S 3
Pin
Bolt, socket
(S/P washer) M3x6
Tab
CMR holder ADJ
Tab
Camera module
Positioning hole
CMR ADJ screw