Advertisement
1
Base plastic
B
A
4
Cable entry channels
Luminaire mounting holes
Base plastic
1 To install the luminaire you must dismantle it to 3 parts.
2 Place a flat blade screwdriver in the area Α to release the diffusor's
plastic hook.
3 Place a flat blade screwdriver in the area B to release the reflector's
plastic hook.
4 Use the included mounting parts to mount the base plastic.
Pass the mains cable thru a cable entry channel. The luminaire must
be connected to a permanent electrical installation to ensure the
immobilization of the cable.
5 Place the battery's connector to the corresponding connector on the
P.C.B.
6 Connect the mains cables to the respective detachable terminal
block. Ν for neutral, L for live wire and L1 for the maintained
operation. The L1 wire can be connected to an external switch to
control the maintained or non maintained operation of the luminaire.
For permanent maintained operation use two wires to power the
luminaire, Ν for neutral and L for live wire, and link the L and L1.
7 Refit the removed parts in steps 2 and 3 (mind the correct
orientation) and the luminaire is ready to operate.
NOTE!!
After finishing the installation you must power the luminaire at least for 24 hours for battery
charging to perform the named autonomy.
Battery replacement.
It can be done only by a competent person and after the mains interruption.
1. Follow the step 2 and 3 of the installation procedure.
2. Disconnect the connector and remove the old battery.
3. Connect the new battery with the same type (step 5 of the installation procedure) and place it in
the position of the old one.
4. Follow the step 7 of the installation procedure and power the device.
Page 4 from 5
INSTALLATION INSTRUCTIONS
Reflector
Diffusor
2
A
5
N
L
External
switch
Controled operation of the luminaire
N
L
Link
Permanent maintained operation
3
B
6
N
L
L
1
923427000_09_005
Advertisement
