Advertisement
Initial installation
1 Untighten the screw and pull up the reflector.
2 Always use in any case round mains cable, with a diameter of 5-10mm (H05RN-F type 2x1mm²
or any other type, at least equal to it's mechanical and electrical properties). Make a hole in the
center of the gasket by using a small screwdriver. Pass the round cable through the gasket. Detach
the power terminal, connect the wires as shown in the picture and attach the power terminal (10A
max). If you use a module (except the wireless module) pass the 2 signal cables on the A, B terminals
minding the correct polarity. Depending on the module that will be used, the cables could have
different names. In A, signals +L, C are also connected, while signals -L, NC/NO are connected on
the terminal B.
3 Refit the reflector (mind the correct orientation), tighten the screw securely and the luminaire is ready
for mounting.
4 Place the battery's connector to the corresponding connector of the luminaire.
5 Mount the luminaire on the ceiling.
NOTE!! After finishing the installation you must power the luminaire for at least 24 hours in
order to completely charge the battery. The rated autonomy duration can be achieved after that
time.
Battery pack replacement.
It can be done only by a competent person and after the mains interruption.
1. Remove the luminaire from the suspended ceiling (figure 3 on page 4).
2. Remove the battery pack from the suspended ceiling.
3. Disconnect the connector and remove the old battery pack.
4. Connect the new battery pack (step 4 of the installation instructions) and place it in the position of
the old one.
5. Place the removed parts back and power the device.
Important notice for the installed luminaires in one area !!!
The installer must connect the battery's connector first and then should power the luminaire.
The time between batteries connection must be, at least 1.5 minute.
With this variation, it is ensured that the non synchronized Automatic Autonomous Test for two or more
luminaires installed in one area, is not conducted in the same day.
Page 3 from 6
INSTALLATION INSTRUCTIONS
Cable
entry
hole
1 1
2
4
923293007_09_001
Advertisement
