Advertisement
ELECTRICAL CONNECTIONS (after the mains interruption)
1
Unfasten the two side cover screws and remove the plastic
cap by sliding it gently. Install the gasket and make a hole in
the center by using a small screwdriver. Pass the round
cable through the gasket.
2
Connect the mains cables to the respective terminal block. Ν
for neutral, L for live wire, L1 for the maintained
operation and the
can be connected to an external switch to control the
maintained or non maintained operation of the luminaire.
For permanent maintained operation use two wires to power
the luminaire, Ν for neutral and L for live wire, and link the L
and L1. The A and B contacts are used only if an optional
module is connected.Refer to the modules manual for more
information regarding connection.
3
The battery is not connected. See the section "Battery
replacement process" to access the battery compartment
and connect the battery.
4
ATTENTION!! Make sure that the ground cable is attached
to the respective ground connector. Replace the removed
parts in the previous steps.
SURFACE MOUNTING ON A WALL (single sided)
Install the included plastic bracket on the wall (figure 1).
5
Remove the aluminum bracket from the luminaire and use
the two supplied mounting screws to install the aluminum
bracket to the plastic bracket (figure 2). Slide the luminaire to
the aluminum bracket and use the bolt on the center (*), to
stabilize the luminaire (figure 2).
CEILING MOUNTING (double sided)
6
Remove the aluminum bracket from the luminaire and install
it with the included spacers, screws and plugs in the ceiling
(page 3). Slide the luminaire to the aluminum bracket and
use the bolt on the center (*), to stabilize the luminaire (figure
4).
7
Power on the device at the end of the installation.
NOTE!! After finishing the installation you must power
the luminaire at least for 24 hours for battery charging to
perform the nominal autonomy.
(*) First, hand tighten it and then,
use pliers to tighten it little bit
more (not all the way).
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
Page 3 from 6
INSTALLATION INSTRUCTIONS
for ground connection. The L1 wire
LED MODULE CHARACTERISTICS
LLB-26/90-LLB-26/180
2405185
4.5W
Non reversible connection between main pcb and led module
45 °C max. across the board
Screws
1
Cable
entry
2
A
Connection Diagramms
L
N
PE
Maintained
operation
(Default)
L
N
PE
Non-maintained
operation
LLB-40/90-LLB-40/180
Olympia Electronics S.A
0204185
14 - 16.5VDC
7.2W
45 °C max. across the board
B
L1
L
N
Ground
connector
L1
L1
L
N
L1
L1
L
N
LLB-64/90-LLB-64/180
2605185+2705185
11.7W
50 °C max. across the board
923064003_09_002
Advertisement
