Omcan VP-NL-0004-SN Instruction Manual page 10

Operation
• When operating a packaging machine with a sensor-based program, the actual vacuum pressure is digitally
shown on the LCD display in mbar (standard setting) or in % vacuum.
PLUG AND PLAY
• When turning on a sensor-based machine for the first time, it will start up in the PA program AUTOMATIC.
This is a pre-set factory program with 5 mbar of vacuum and 2 seconds of sealing time.
• When turning on the machine after that, it will start up in the most-recently used program.
OPTIONAL INSTALLATION OF SOFT-AIR
• The soft-air feature can also be installed at a later date by ordering the optional soft-air kit.
OPERATING THE MACHINE WITH TEN-PROGRAM CONTROL SYSTEM
On: turns the machine on:
• The machine will start up in the most-recently used program.
• The pump of a machine with a transparent cover will start when the cover is closed.
Off: turns the machine off:
• When pressing the
after about 4 seconds.
• When pressing the
• Closing the cover will initiate the cool-down phase.
• The machine will complete a number of vacuum cycles before turning off automatically.
Stop-function:
• Stops the machine at any point in the cycle and aerates the chamber.
Reset-function:
• While programming, resets the program value to its original setting.
• Press the menu button
Back function:
• While reviewing programmed values, returns to the previous selection.
Stops the active function and initiates the next step in the cycle:
• While the machine is running, exits the active function and jumps to the next step in the cycle.
• While packing sauce or soup, the package may be sealed as soon as product boiling is
detected.
Menu button:
• Toggles between home menu
• Save function: during programming, confirms and saves the entered program values and
returns to the home menu.
• Return function: returns to the home menu.
review program values:
•
• Displays the programmed value for each function; the function being reviewed will be
blinking.
•
• Returns to the home menu.
button once, the
button a second time, the pump will stop immediately.
to return to the home menu.
Cycles through programs P1 to P9, as well as PA and P H2O.
Displays the value for the next function.
symbol will start blinking and the pump will stop
and settings menu
10
.