Teledyne Linea CL LA-CM-08K08A User Manual page 76

LPC: Load Pixel Coefficients
Display
Load Pixel Coefficients
Name
Mnemonic LPC
Argument(s) Set selector
Description Load user set
Notes 
RC: Reset Camera
Display Reset Camera
Name
Mnemonic RC
Argument(s)
Description Resets the camera to the saved user default settings. These settings are
saved using the usd command.
Notes The micro-controller reboots:







ROI: Set Flatfield ROI
Display Set Flatfield ROI
Name
Mnemonic ROI
Argument(s) First pixel
Last pixel
Description Flat field region of interest
Notes 

74  Appendix B: ASCII Commands
Loads FPN coefficients and PRNU coefficients from a user set ( only
coefficeints, no other camera parameters)
Load any file updates
Clear over temperature condition
Perform start up camera tests (BiST)
Load FPGA code
Configure FPGA and sensor.
Load default user set
Baud rate set to 9600
1 to 2048 (2k)
1 to 4096 (4k)
1 to 8192 (8k)
1 to 16,384 (16k)
1 to 2048 (2k)
1 to 4096 (4k)
1 to 8192 (8k)
1 to 16,384 (16k)
Specifies the pixels that CCF and CPA will calibrate
Pixel coefficients outside this region are not changed
o
Last pixel must be greater than or equal to first pixel
0. Factory set
1-8. User sets
Linea CL Series Camera