Teledyne Linea CL LA-CM-08K08A User Manual page 39

To calculate the maximum line rate:
Maximum line rate =
*Exposure time must be greater than 4 s, and low time greater than 1 s (2k, 4k and 8k models)
or greater than 2 s (16k model)
GenICam parameters to set:
 I / O Controls > Trigger Mode > Off
 Camera Control > Internal Line Rate > user value
 Camera Control > Exposure Time > user value
External Programmable Exposure
The External Programmable Exposure mode is similar to Internal Programmable except for the
exposure start being an external user input.
 The TriggerSource feature (see I/O Control category) selects an external signal line as trigger.
 Line rates and exposure limits are as defined for Internal Programmable Exposure.
 The falling edge of the EXSYNC (CC1) signal triggers the start of the internal exposure.
CC1
Programmable Exposure
1. Exposure time > 4s (all models)
2. Sensor readout time = 12.5s (2k, 4k, 8k) or 20.8s (16k)
3. LVAL delay = ~14.5s (2k, 4k), 26s (8k) or 41s (16k)
GenICam parameters to set:
 I / O Controls > Trigger Mode > On
 Camera Control > Exposure Time Source > Timed
 Camera Control > Exposure Time > user value
Linea CL Series Camera
(���������������� ��������+������ ��������∗)
Line Time
> 1 s (2k, 4k, 8k)
> 2 s (16k)
1
Programmable Exposure
2
Sensor Readout
LVAL
3
LVAL delay
1
1
Sensor Readout
1
Programmable Exposure
2
Sensor Readout
Camera Operation  37
2