Table of Contents
Advertisement
The parameters that control gain and black level are grouped together in the Camera Control
category.
Camera Control
Single value added to each pixel. Apply a digital addition after an FPN correction: ±
Offset
1/8 of available range. Positive values may be used to measure dark noise.
Depending on the the pixel format, different offset ranges are available:
12-bit mode
8-bit mode
Floating point digital multiplier applied to each pixel. Set the gain as an amplification
Gain
factor applied to the video signal across all pixels: 1x to 10x.
Related ASCII Commands
ssb
set sensor blacklevel
ssg
set sensor gain
Linea CL Series Camera
available range is -512 to +511.
available range is -32 to +31.
Camera Operation 33
Advertisement
Table of Contents
