Table of Contents
Advertisement
Loewe bild 5 oled / bild 4 oled
User handbook
Preparing the TV set
Installing the TV set
Mounting options / Installation notes
Your Loewe dealer can also assist you in finding other mounting
options. Look for the corresponding directions in the installation
instruction.
Choose a place for installing your TV set where no bright light or
sunlight shines directly onto the screen. This could cause reflections
which impair the picture.
3 times the screen diagonal can be taken as a guide value for the
viewing distance (e.g., for a 55-inch set approx. 4.2 m for SD signal).
The viewing distance can be reduced with an HD/UHD signal.
Set covers
Covers for rear and side connections
In order to remove the rear side cable covers pull them simply from
the device.
To fit the cover, insert the lugs at the top edge of the cover into the
corresponding cut-outs in the rear panel and push up the cover until
it snaps in.
The side cover of the TV set can also be completely removed. For this,
open it as far as it will go and gently pull on the open cover.
The cover detaches from the holder and gives free access to the
connection area. To replace the cover, simply push it until it latches
back into place.
A cable bushing connects the lateral and posterior terminal region. In
this way you can pass the cables of the lateral connections through
and lay them out together with the rear connecting cables.
Cable fixing
Using the Velcro cable tie supplied, you can fix the rear cables.
When the TV set is mounted on the Table Stand, the connection cables
are fixed to the Table Stand (see figure).
When using a wall bracket (Wall Mount is available as an accessory
from your specialist dealer), the connection cables are fixed to the
two recesses on the rear of the device (see figure).
Table Stand
With the detachable cable holders
connection cables to the rear of the housing.
A
Wall Mount
A
, you can additionally fix the rear
A
11
Advertisement
Table of Contents
