Loewe bild 5 User Handbook Manual page 99

Loewe bild 5 oled / bild 4 oled
User handbook
System settings
Multimedia / Network
Configuration of the built-in LAN adaptor
As network operation was selected On, wired only.
IP
configuration
... You can define the necessary parameters for the IP configuration yourself
Networking
("manual") or set this to be done automatically. The automatic setting occurs
through a DHCP server or by means of several protocols in accordance with the
"Universal Plug and Play" specification (UPnP)."
Automatic
Back with
Select type of IP configuration.
automatic Automatic configuration of the IP address via DHCP
server or via multiple protocols according to UPnP
specification (including DHCP).
After selecting IP configuration – automatic
proceed to the network status.
manual Enter your fixed IP addresses manually.
If manual has been selected under IP configuration:
Manual IP-
configuration Please specify the static IP address of the network adapter.
... Networking
IP address
Subnet mask
Gateway
DNS server 1
DNS server 2
Back with
Enter IP, Subnet mask, Gateway and DNS server
addresses in succession with the numerical keys
on the remote control.
Proceed to network status.
Network
status
...
Networking
Current settings:
Networking
IP configuration
Additional information:
IP address
Subnet mask
Gateway
DNS server 1
DNS server 2
MAC address
Proceed with
You see the current network status again.
BACK: End of wizard.
IP configuration
.
Manual
Proceed with
Manual IP configuration
.
192.168.000.123
255.255.255.000
192.168.000.100
192.168.000.010
192.168.001.010
Proceed with
NETWORK WIZARD - Network status
.
Wired
Automatic
172.16.10.141
255.255.0.0
172.16.0.1
172.16.0.1
192.168.1.1
18:16:0f:71:af:92
End with
Configuration of the built-in WLAN bridge adaptor
As network operation was selected On, wireless only.
The TV set now searches for wireless routers.
Access point
selection Please choose the access point to which the TV should connect.
... Networking
Note: The newly selected parameter must be confirmed with the
Search again
Back with
After the end of the search:
Select a base station to which the TV shall be
connected.
OK Confirm selection and proceed to the entry of the
Wi-Fi password.
If the desired access point is not found:
Mark Search again,
OK repeat search for wireless routers.
Or:
Mark Enter access point manually,
OK enter manually the SSID of the desired access
point, e.g., when the SSID of the access point is
not transferred.
WPA
passphrase The selected base station uses WPA encryption, for which a password consisting
... Networking
of between 8 and 64 characters is required. Please insert it in the dialogue
below.
Back with
The TV set automatically detects the type of encryption
used and informs you. You will find the supported
encryption types in chapter Technical data.
If your wireless network is not encrypted: Proceed to
IP configuration.
Proceed to password entry.
Enter WLAN password.
In case of an unknown WLAN key, contact your
network administrator.
For WEP encryption
Select the WEP index,
OK proceed to IP configuration.
Select type of IP configuration.
For the further workflow of the network wizard
see left column under IP configuration.
Access point selection
button.
. OK
FritzBox 7490
Netgear
Router ABC
Enter access point manually
Proceed with
WPA passphrase
.
Proceed with
99