Manual Scan Tv / Radio - Loewe bild 5 User Handbook Manual

Loewe bild 5 oled / bild 4 oled
User handbook
System settings
Stations
Search for/update stations – handling of new and no longer
found stations
After the automatic search/update has been concluded, the number
of newly found TV and radio stations is shown.
Call list of new TV stations found.
Select station.
OK Mark / unmark station.
Stores the marked TV stations.
Afterwards, a list of the stations which are saved but
which are temporarily not broadcasting or no longer
exist is displayed, if available.
The number of the memory location used is displayed
in front of the station. Please select the stations you
really want to delete.
Select station.
OK Mark / unmark station.
Proceed. The marked TV stations will be deleted.
Subsequently the process of Newly found
stations/Stations no longer found shall be
carried out in the same way for the radio stations.
Back: Close search assistant.

Manual Scan TV / Radio

Here, you can enter all the settings available for a station. However,
this requires detailed knowledge.
The manual search of radio stations is similar to that of TV stations.
Therefore, the manual search for radio station is not dealt with
separately.
Calling manual search
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Stations,
go to next column.
Mark Manual Scan (incl. antenna status),
OK call Manual Scan.
Select the menu item Signal source to decide in which
area you want to search for stations.
Depending on the selected source, various setting
possibilities will be available.
On the next page, the settings for analogue cable and
DVB-T/C/S sources are described separately.
Status bar for manual search
Status bars are displayed for manual search, which
show the reception quality of the individual stations
during the station scan. The markers in all bars should
preferably be in the green area.
C/N: (Carrier/Noise) The bar shows the signal-to-
noise ratio. The value indicated in dB should be
preferably high.
Level: The bar shows the receiving level of the station.
The value displayed in dBμV should be preferably high.
BER: (Bit Error Rate) The bar shows the bit error rate
of the station. The value for BER should be as low as
possible.
77