Network Settings - Loewe bild 5 User Handbook Manual

Loewe bild 5 oled / bild 4 oled
User handbook
System settings
Multimedia / Network

Network settings

Under Network settings you make settings to your network adaptors
and the various types of media.
Call network settings
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Multimedia / Network,
go to next column.
Mark Network settings,
go to next column.
... Network
Networking
settings
Host name
Proxy server
Wake on
LAN/WiFi
Select desired menu item,
go to next column.
Explanations of the setting options in the network menu:
Networking Here, the network wizard starts that guides you
through all necessary settings to your network (see
right hand column).
Host name Give your TV set a name so that it can be uniquely
identified in the network.
Proxy server Do the settings for using a proxy server. The proxy
server wizard will be called.
See chapter System settings, section Multimedia
/ Network – Proxy server for further information.
Wake on Here you can specify whether it is permitted to
LAN/WiFi access your TV set by LAN/WLAN in standby mode.
This allows you to switch on your TV, for example.
Please note that the TV set consequently uses more
power in standby mode.
After switching off the TV set into standby mode,
it takes minimum 30 seconds for the TV set to
be ready for reception of a signal (Wake on LAN/
WLAN) to power on via LAN/WLAN.
If you want to switch on your TV set via the Loewe
App by Wake on WLAN, you have to configure in
your router's encryption permanently on WPA2.
Setting WPA / WPA2 may not be used.
98
The following antenna wizard guides you through all the
necessary settings relevant to your network.
Network
The network wizard guides you through all the necessary settings
relevant to your network
At the beginning you see the current network status.
Network
status
...
Networking
Current settings:
Networking
IP configuration
Additional information:
IP address
Subnet mask
Gateway
DNS server 1
DNS server 2
MAC address
Proceed with
Proceed to next step.
Security hint
... Networking
This next step allows you to connect your TV device to the Internet. This enables
you to use of a number of different services and get the most out of your
device's technical capabilities.
For data protection reasons, we would like to point out that once the device is
connected to the Internet data will be transferred between your TV device and
the Internet as this is a prerequisite for use. As a result, your TV device is subject
to the same risks and dangers as any other device with Internet capabilities, e.g.
computer, smartphone, etc.
In this respect, Loewe guarantees that this data will not be personally exploited
in any way. However, a statistical analysis of anonymised data records may be
carried out. If you have any questions, please contact your dedicated Loewe
advisor or call the Loewe Hotline.
Back with
Proceed to next step.
Network
mode
... Networking
Please select the desired network mode from the list or switch it off completely.
Off
On, wired only
On, wireless only
Back with
Select network mode.
Select how you want to connect your TV set to
your network.
OK Confirm selection.
Off Deactivates all existing network adaptors of your
TV set.
On, wired Access to the network only via a network cable.
only The wireless access is deactivated.
On, wireless Access to the network only via WLAN.
only The access via a network cable is deactivated.
Depending on which type of network (wireless or wired)
was selected, the appropriate settings appear below.
NETWORK WIZARD - Network status
.
Wired
Automatic
172.16.10.141
255.255.0.0
172.16.0.1
172.16.0.1
192.168.1.1
18:16:0f:71:af:92
End with
Internet Security hint
.
Proceed with
Select network mode
.
Proceed with