Preparing The Tv Set; Installing The Tv Set; Cable Routing; Loewe Bild 9 Cover - Loewe bild 9 Operating Manual

Loewe bild 9
Operating manual

Preparing the TV set

Installing the TV set

Only use one of the three available set-up options for your Loewe bild
9 TV set: FS 9 (Floor stand), WM 9 (Wall mount) or TS 9 (Table stand).
Please take note of the information regarding the corresponding
mounting instructions.
Choose a place for installing your TV set where no bright light or
sunlight shines directly onto the screen. This could cause reflections
which impair the picture.
3 times the screen diagonal can be taken as a guide value for the view-
ing distance (e.g., for a 55-inch set approx. 4,2 m for SD signal). The
viewing distance can be reduced with an HD/UHD signal.
Cable feed-through
A cable bushing connects the lateral and posterior terminal region. In
this way you can pass the cables of the lateral connections through and
lay them out together with the rear connecting cables.

Loewe bild 9 cover

You can cover the back of the bild 9 with the cover supplied with the
Loewe bild 9. You can easily access the TV set's connections using
the magnetic flap system.
For how to position the Loewe bild 9 cover, see the mounting instruc-
tions for the set-up option used (example illustration: TV set bild 9
with set-up option FS 9).

Connecting the TV set

Connecting to the mains supply
Remove the cover for the connections.
Connect the TV set to a 220-240V mains socket:
First plug the smaller plug (small connector) of the power cord into
the AC inlet (AC IN) on the TV set, and then the larger connector (Euro
plug) into a mains socket.
Connecting antennas
Cable (analogue) / DVB-C / DVB-T antenna:
Plug the cable of antenna, cable TV system or room antenna into the
ANT TV socket.
If you want to use analogue cables / DVB-C connection and a DVB-T
antenna together, use an external antenna switch (available from
your dealer).
Satellite antenna DVB-S:
Depending on the used satellite system, connect a connecting cable
from the multi-switch or directly from the LNC to the ANT-SAT and
ANT-SAT2 sockets of the TV set respectively.
When connecting the TV set to a single cable community antenna,
connect the ANT-SAT and ANT-SAT2 sockets directly to the
appropriate SAT antenna socket.
When connecting the TV set to a DiSEqC single cable community
antenna (in accordance with EN 50494), connect the ANT-SAT
socket directly to the appropriate SAT antenna socket.
In case of a DiSEqC one cable communal system you require only
one antenna cable. Further distribution of the signal to the two
reception routes is accomplished by the TV set's satellite tuner.
It is possible, however, to continue using an existing SAT cabling
with two antenna cables in a DiSEqC one cable communal system.
If two transmission channels of the DiSEqC single cable community
exist, one system channel is used per satellite antenna cable.
Ask your dealer in this regard.
Cable DVB-T
analogue /
DVB-C
R TV
DVB-S
9