Table of Contents
Advertisement
Loewe bild 5 oled / bild 4 oled
User handbook
Initial installation
Setting options for the satellite system (single satellite):
Select
single satellite
Select satellite,
OK Confirm selection.
Proceed to next step.
Dual/single
band
Select Dual band (low/high) or Single band.
OK Confirm selection.
Here you specify if you use a Dual Band (Universal)
LNB or a Single LNB.
Proceed to next step.
LNC
frequencies
Set LNB frequencies.
OK Adopt settings.
The setting of the LNB frequency is only called
when you have used the setting Single band
in step Dual / single band.
Normally, you do not need to change the values
for high and low band, unless the LNC (LNB) of
your satellite system uses a different oscillator
frequency (important for the frequency display).
Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
24
Setting options for the satellite system (2 satellites on 22
kHz switchbox / 2 satellites on toneburst switch):
Satellite
selection
Mark Satellite 1 / Satellite 2,
select satellite.
OK Adopt settings.
Proceed to next step.
LNC
frequency
(22 kHz
Switch box)
LNC
frequencies
(Toneburst
switch)
Set LNB frequencies.
OK Adopt settings.
Normally, you do not need to change the values
unless the LNC (LNB) of your satellite system
uses a different oscillator frequency (important
for the frequency display).
Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
Advertisement
Table of Contents
