Table of Contents
Advertisement
Reference 55-85
User manual
Preparing the TV set
Installing the TV set
Mounting options / Installation notes
Your Loewe dealer can also assist you in finding other mounting
options. Look for the corresponding directions in the installation
instruction.
The four round self-adhesive covers that are supplied with the TV set,
are used as a cover of the four rear panel openings when installing the
TV with Floor Stand Reference 75 / 85 MU.
Choose a place for installing your TV set where no bright light or
sunlight shines directly onto the screen. This could cause reflections
which impair the picture.
3 times the screen diagonal can be taken as a guide value for the
viewing distance (e.g., for a 55-inch set approx. 4.2 m for SD signal).
The viewing distance can be reduced with an HD/UHD signal.
Cable fixing
Reference 55:
Using the Velcro cable tie supplied, you can fix the rear cables.
When using the table or floor stand, they are to be fixed at the mounting
option (see corresponding installation instructions).
When using the wall mount, you can feed the Velcro cable tie through
the two openings of the rear panel.
with table or floor stand
Reference 75 / 85:
With the self-adhesive cable supports supplied, you can fix the
connecting cables.
You can determine the position of each cable support according to
your needs. The figure contains an exemplified positioning.
12
Set covers
Reference 55:
In order to remove the rear side cable covers pull them simply from
the device.
To fit the cover, insert the lugs at the top edge of the cover into the
corresponding cut-outs in the rear panel and push up the cover until
it snaps in.
The side cover of the TV set can also be completely removed. For this,
open it as far as it will go and gently pull on the open cover.
The cover detaches from the holder and gives free access to the
connection area. To replace the cover, simply push it until it latches
back into place.
A cable bushing connects the lateral and posterior terminal region. In
this way you can pass the cables of the lateral connections through
and lay them out together with the rear connecting cables.
Reference 75 / 85:
To remove the two parts of the cable cover, use for each half the two
with wall mount
grip recesses at the bottom of the device. Pull the covers carefully
away from the TV set.
The side cover can be swung open.
A cable bushing connects the
lateral and posterior terminal
region. In this way you can
feed the cables of the lateral
connections through and lay
them out together with the rear
connecting cables.
To fit the cover, place the upper
edge of the cable cover at the
TV set and press the guides
into the profiles of the rear
panel until the cover snaps into
place on the TV.
If necessary, move the cover
up until it is flush with the stop.
Advertisement
Table of Contents
