Table of Contents
Advertisement
Loewe bild 5 oled / bild 4 oled
User handbook
Initial installation
Setting options for the satellite system
(max. 4 satellites on DiSEqC multiswitch):
DiSEqC
multiple
switch
Select and adapt settings for the DiSEqC
multiswitch.
OK Adopt settings.
Repeat rate The refresh rate determines how often a DiSEqC
command is output. A refresh is only necessary with
cascaded systems.
Control
The control voltage controls the switching of the
voltage
polarisation level (horizontal/vertical) in non-DiSEqC
capable components (e.g., control of single LNBs via
DiSEqC multiswitch).
22kHz signal The 22 kHz signal controls the switching between
high and low band in the Band setting. The Position
setting controls the selection of the satellites in non-
DiSEqC capable components.
Toneburst The Toneburst controls the selection of the satellites
in non-DiSEqC but Toneburst capable components
with the Position and Option settings.
Proceed to next step.
Satellite
selection
Mark Satellite 1 ... Satellite 4,
Select satellite.
OK Adopt settings.
Proceed to next step.
LNC
.
frequencies
Set LNB frequencies.
Normally, you do not need to change the values.
OK Adopt settings.
Proceed to next step.
Proceed to section Setting options for DVB-S
reception (continued).
25
Advertisement
Table of Contents
