Loewe bild 5 User Handbook Manual page 127

Loewe bild 5 oled / bild 4 oled
User handbook
Troubleshooting
Problem
The TV set switches off automatically.
All menus are displayed in the wrong lan-
guage.
General problems when connecting external
devices via an AV input.
With Teletext various characters are
displayed incorrectly.
Errors occurred when running a CA module.
No sound via the external digital audio am-
plifier.
A programmed recording was not made.
There is no start or end of a programmed
recording although the automatic time
control (Accurate Recording) was used.
No IP address will be issued to your TV set in
spite of automatic IP configuration.
Possible cause
The automatic shutdown switches off the
TV set to save energy after 4 hours of
inactivity as soon as at least one signal input
group is set up in the energy efficient mode
Home Mode.
The menu language was set incorrectly.
The Signal type is set incorrectly.
The wrong character set has been set in the
System settings.
a) The external digital audio amplifier does
not support the selected sound format
(Dolby Digital, dts, MPEG).
b) TV set and external digital audio amplifier
are not connected with each other.
The provider deleted the programme from
the EPG data, for example due to a programme
change.
The station from which the recording was
made does not support automatic time
control (Accurate Recording).
The transmission time of the program was
delayed and the channel from which the
recording was made has not updated the data.
No DHCP server is working on your network. Set up a DHCP server.
Remedy / Instructions
Using automatic shutdown is recommended
for the purposes of energy saving and safety.
Set the menu language:
Press HOME key. Call last menu item
(bottom left). Mark the fourth item from above
in the following list and move to next column to
the right. Call first list item with OK. Select the
language and confirm it with OK.
Set the correct signal type (System settings
Connections AV connection settings
Signal type).
If AV standard or Signal type is set to
"Automatic" then this can lead to false
detections with non-standard signals. In this
case standard and signal must be set according
to the information in the operating manual of
the external device.
Set the correct character set: System
settings Control more ...
Teletext Character set
select the appropriate character set.
Switch the TV set off. Remove the CA-module
from the TV set. Wait a few seconds. Reinsert
the CA module. Switch the TV set on again.
a) Set PCM stereo on the DVD player in the
sound selection. For DVB stations switch
Language/Sound
b) Connect SPDIF OUT from the TV set to a
digital input of the external digital audio
amplifier and select the appropriate input
to this.
Only the broadcasting organisations are
responsible for transmitting data for the
automatic time control. The availability of
the appropriate data cannot be guaranteed.
Only the broadcasting organisations are
responsible for transmitting data for the
automatic time control. The availability of
the appropriate data cannot be guaranteed.
Assign the IP addresses for the TV set
manually.
Standard
Standard or
127