Inspection And Cleaning Of Radiator And Water Hoses - Linhai CROSSFIRE 600GT Service Manual

CHAPTER 3 ENGINE
3.6.3 Inspection and Cleaning of Radiator and
Water Hoses
Radiator Cap
Remove radiator cap①
Install radiator cap to cap tester②
Slowly increase pressure to 110-140 kPa and
check if the cap can hold the pressure for at least
10 seconds.
If the cap cannot meet the pressure requirement,
replace it.
Radiator Cap Valve Opening Pressure:
Standard: 110-140 kPa
Tool: Radiator Cap Tester
Radiator Inspection and Cleaning
Remove dirt or trash from radiator with compressed
air;
Correct the radiator fins with a small screwdriver;
Radiator Hose Inspection
Check radiator hoses for leakage or damage.
Leakage or Damage: → Replace
Check tightening of clamps. Replace the clamps if
necessary;
After inspection and cleaning of radiator and hoses,
check coolant level. Fill coolant if necessary.
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE PAGE. 3- 125