Advertisement
CHAPTER 3 ENGINE
Check starter clutch roller and holder for abnormal
wear or damage.
Wear or damage: → Replace
Install the starter clutch in the correct direction.
Note:
When install the starter clutch to the magneto rotor,
make sure side "A" is in the right direction.
Face arrow mark "B" to the engine side;
Apply engine oil to starter clutch.
Apply thread locker to bolt and tighten to the
specified torque:
Tightening torque of starter clutch bolt: 30N•m
Material: Thread Locker
Install the starter driven gear
Make that the starter driven gear turns in the
opposite direction of the arrow mark "B". The gear
cannot turn in the direction of the arrow.
Check starter driven gear bearing. In case of
anything unusual, replace the bearing.
Remove starter driven gear bearing with special tool
Install starter driven gear bearing with special tool.
Tool: Bearing Installer/Remover
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE
PAGE. 3- 80
Advertisement
Chapters
